RM新时代入口-首页

馬鞍山鮑米勒伺服驅動器維修服務：719：Timeout during motor identification電機識別超時。Error during identification of motor parameters. The maximum permitted phase voltage (= 80 V) was exceeded during the resistance measurement.識別電機參數時出錯。在電阻測量過程中，超過了每個允許相的最大電壓（=80V）。

Possible cause: 原因：

Incorrect motor nominal current setting in Parameter 107.09.

參數107.09中的電機標稱電流設置不正確。

Effect: Output voltage set to ZERO to protect the motor. An additional drive block occurs with standard error response.

效果：輸出電壓設置為零，以保護電機。附加的驅動器塊出現標準錯誤響應。

Resetting after error elimination: 錯誤消除后重置：

Error reset is possible. Timeout (45 seconds) with R measurement with motor parameter identification, such as due to error during current / voltage measurement or normalization or limit value.錯誤重置是可能的。電機參數識別的R測量超時（45秒），例如由于電流/電壓測量或標準化或限值過程中的錯誤。