RM新时代入口-首页

普陀區包米勒伺服驅動器維修：

1100Drive manager general error pulse enable

驅動器管理器一般錯誤脈沖使可能。

When a pulse block has no reason that can be recognized by the drive manager (AM) (recognizable are: digital input, error with response pulse block, command control word), there is a threat of an endless change of statuses in the AM:

當脈沖塊沒有驅動管理器（AM）可以識別的原因（可識別的有：數字輸入、響應脈沖塊錯誤、命令控制字）時，AM中存在狀態無休止變化的威脅：

Statuses 2->3->2 etc. are continuously processed because all switching conditions are met and the AM continues to attempt to activate the drive.

狀態2->3->2等將被連續處理，因為所有開關條件都已滿足，AM將繼續嘗試激活驅動器。

To prevent this, the change in status 3 will be disabled when a pulse block is recognized, a marker will be set and the error RC_ERR_DMGR_IF is entered for signaling.為了防止這種情況，當識別到脈沖塊時，狀態3的改變將被禁用，將設置標記，并輸入錯誤RC_ERR_D MGR_IF用于信令。

No change is possible in Status 3 as long as the marker is set.

只要設置了標記，狀態3就不可能更改。

Effect: The drive switches to Status 15 (Error). Other responses are no longer permitted so that the drive cannot automatically restart in the case above (pulse block without entering a error with pulse block) after Error #1100 has been reset.

影響：驅動器切換到狀態15（錯誤）。其他響應不再被允許，使得在錯誤#1100被重置之后，在上述情況下驅動器不能自動重新啟動（脈沖塊而沒有用脈沖塊輸入錯誤）。